Angled Lower And Upper Knife Set Jack 798D Industrial Overlock Machine Model 20719050

Replace and Upgrade Your Jack 798D Overlock Machine with the 20719050 Angled Lower and Upper Knife Set

Changing the blades on your industrial overlock machine is a straightforward process:

1. Ensure the machine is powered off and disconnected for safety.

2. Locate and remove the screws holding the old blade in place, usually found underneath the machine.

3. Carefully extract the old blade, being mindful of its sharpness.

4. Align the new blade properly in the blade holder, following the manufacturer's instructions for correct positioning.

5. Secure the new blade in place by reinserting and tightening the screws.

6. Double-check the blade's movement to ensure smooth operation and proper alignment.

7. Test the new blade by running a few stitches on scrap fabric to verify its cutting performance.

Always refer to your machine's manual for specific guidance, and if you're unsure, seek assistance from a professional technician or reach out to Konsew LTD for expert support.